I had actually tried to install this driver before posting this question because the Section 10 of the Getting Started Guide (GSG) says to do so. After ufedor’s reply here, I got a reply from a support technician with suggesting to install the driver at. the RDB I have).īecause I am new to NXP, I actually posted this question on both and here at. the board that addresses) is the same for the LS1046A (i.e. According to and application note included in the download on, the binary image for the LS1012A (i.e. After disconnecting from and plugging back into the console port on the RDB, I found that while the laptop now recognized a storage device named “MBED” as expected, the expected serial port was still not recognized. Following the post at, which primarily refers to the post at, I downloaded the binary image from, unzipped it, connected the RDB to the laptop via USB, and copied the binary image to the BOOTLOADER drive. I did note at this point that the laptop started to temporarily identify a “mass storage device” named “BOOTLOADER” when the USB was connected (the switches have been returned to the configuration shown in Table 9 of the GSG ). Following the application note at, after identifying that the latest version of the Layerscape SDK was 20.04, I downloaded the latest QSPI U-Boot image from, wrote the downloaded image to a 16GB SD card using Win32 Disk Imager, altered the switches to boot from the SD card as described in Table 2 in (and later ), but still the laptop failed to recognize a serial port. Since the laptop was not recognizing any device was connected, I began to be suspicious that the RDB may have corrupted memory. Looking into the problem further, I found that the device manager on the laptop did not recognize any device was connected when the USB cable was connected from the laptop to the console port on the RDB. SW3, SW4, and SW5 on the RBD) to the configuration described in Table 9 of the GSG, but I was unable to establish a serial connection with either Tera Term or Moba XTerm. I am expecting to be able to establish a console connection via the “console” USB port on the front panel of RDB as described in Section 10 of the GSG. I am using a laptop running Windows 10 Enterprise (version 1803, 64-bit) and, according to the page at, a serial driver should not need to be installed for Windows 10. Unfortunately, the laptop I am developing with does not recognize a serial port from the RDB. ĭigital Media Kit for Windows runs on the following operating systems: Windows.ĭigital Media Kit for Windows has not been rated by our users yet.I am just getting started with an LS1046A-RDB (referred to hereafter as the RDB) and I have been following the Getting Started Guide. It was initially added to our database on. ![]() Overviewĭigital Media Kit for Windows is a Shareware software in the category System Utilities developed by The latest version of Digital Media Kit for Windows is currently unknown. If you are concerned with the performance or reliability of your USB or Memory Card, this application is the ideal choice. ![]() In many cases this will fix any logical read errors on the digital media. The repair features even include: Backup, Wipe, Format and Restore. ![]() The easy-to-use interface enables you to diagnose your media with just a few mouse clicks. Digital Media Kit will allow you to perform several tests and even attempt a repair on your digital media. Digital Media Kit is a handy Digital Media stability and reliability testing software.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |